View Single Post
zippy
Veteran Member
 
Join Date: Jul 2005
Location: Unknown
 
2007-04-04, 11:37

Ooohh, Bonanza!

I also found this little number:


Hmm.. both for $5.78 plus shipping. I'll need to consult with my accountant, but this is just too damn important to pass up. My fellow ANers at the very least are in dire need of proper info - right?

OK, stop twisting my arm, I'll do it.

I'm headed for financial ruin. There's no question.

Results just wouldn't be accurate without also getting this little unit:


That's another $5.99 plus shipping.

Damn you Amazon.......................

Edit: Damn you auto post merging....................

Quote:
Originally Posted by johnq View Post
After opening and pouring a drink...

1. Insert deflated balloon in bottle.
2. Inflate baloon as much as possible.
3. Tie and stuff the end into the bottle.
4. Recap the bottle.


EDIT: or buy the above thingy.

Hey, are we talking science experiment or practicality?

EDIT 2: Or how about this? (Less spittle this way)
1. Insert deflated balloon in bottle.
2. Inflate baloon as much as possible.
3. Tie the end. No need to cap.
Hmm.. good ideas. Methinks non-latex would be safest - just in case we have company. This could be a cheaper solution - depending on how long any of the above units last (assuming they work, but then the advertisements say they do, so they must, right?). Removal of the balloon needs to be done with care - a quick pop, might disturb the soda and cause a sudden rush of CO2 release. Also, I wouldn't want shards of balloon floating around. But a carefull Snip right near the knot should allow for a slower release, and complete removal of the balloon.

Do you know where children get all of their energy? - They suck it right out of their parents!

Last edited by zippy : 2007-04-04 at 11:37. Reason: Posts merged
  quote